Cutting tool performance in end milling of glass fiber-reinforced polymer composites

Bílek, Ondřej; Žaludek, Milan; Čop, Jiří

Název:

Autor:

Bílek, Ondřej; Žaludek, Milan; Čop, Jiří

Typ dokumentu:

Recenzovaný odborný článek (English)

Zdrojový dok.:

Manufacturing Technology. 2016, vol. 16, issue 1, p. 12-16

ISSN:

1213-2489 (Sherpa/RoMEO, JCR)

Journal Impact This chart shows the development of journal-level impact metrics in time

JCR	Journal Citation Reports - Impact Factor
SNIP	SCImago Source Normalized Impact per Paper
SJR	SCImago Journal Rank
IPP	SCImago Impact per Publication
CS	Scopus CiteScore

(Note: The metrics are not comparable against one another.)

DOI:

https://doi.org/10.21062/UJEP/X.2016/A/1213-2489/MT/16/1/12

Abstrakt:

The article deals with the machining of glass fiber-reinforced thermoset composite. Emphasis is placed on the selection of cutting tools for end milling. Experiment involved slot milling by special tools for composite machining with different geometries and surface coating. Further, the quality of the machined surface, cutting performance, dimensional accuracy, delamination factor and tool wear were evaluated. The results were compared with the end milling of carbon fiber-reinforced polymer composites. © 2016. Published by Manufacturing Technology.

Plný text:

http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-1.pdf

Zobrazit celý záznam

Soubory tohoto záznamu

Název: Fulltext_1006535.pdf

Velikost: 827.4Kb

Formát: PDF

Popis: fulltext

Citace ČSN ISO 690:2011

Citace článku v časopise:
BÍLEK, Ondřej, Milan ŽALUDEK a Jiří ČOP. Cutting tool performance in end milling of glass fiber-reinforced polymer composites. Manufacturing Technology [online]. 2016, vol. 16, iss. 1, s. 12-16. [cit. 2024-04-24]. ISSN 1213-2489. Dostupné z: http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-1.pdf.

Tyto citace vytvořil software a mohou obsahovat chyby. Pro ověření přesnosti si nastudujte příslušnou citační normu nebo příručku.