Publikace UTB
Repozitář publikační činnosti UTB

The Influence of runner system on production of injection molds

Repozitář DSpace/Manakin

Název: The Influence of runner system on production of injection molds
Autor: Janoštík, Václav; Staněk, Michal; Maňas, David; Maňas, Miroslav; Šenkeřík, Vojtěch
Typ dokumentu: Článek ve sborníku (English)
Zdrojový dok.: MATEC Web of Conferences 20th International Conference on Circuits, Systems, Communications and Computers (CSCC 2016). 2016, vol. 76
ISSN: 2261-236X (Sherpa/RoMEO, JCR)
Journal Impact This chart shows the development of journal-level impact metrics in time
JCR Journal Citation Reports - Impact Factor
SNIP SCImago Source Normalized Impact per Paper
SJR SCImago Journal Rank
IPP SCImago Impact per Publication
CS Scopus CiteScore
(Note: The metrics are not comparable against one another.)
DOI: https://doi.org/10.1051/matecconf/20167602022
Abstrakt: This experimental study describes the influence of runner system on rheological properties during the injection molding process. Economic effects on the amount of production are discussed as well. Autodesk Moldflow Synergy 2016 (Moldflow) was used for the study of the injection process. Three suggestions of the runner system, cold runner system, hot runner system and the combination of cold hot runner system have been promoted. These three variants underwent the rheological and economic analysis. As a result, recommendations for the application of the runner system for the required amount of production have been suggested.
Plný text: https://www.matec-conferences.org/articles/matecconf/abs/2016/39/matecconf_cscc2016_02022/matecconf_cscc2016_02022.html
Zobrazit celý záznam

Find Full text Export to RefWorks
   

 

Soubory tohoto záznamu

Icon
Název: Fulltext_1006992.pdf
Velikost: 1.221Mb
Formát: PDF
Popis: fulltext
Zobrazit/otevřít

Citace ČSN ISO 690:2011

Citace článku v konferenčním sborníku:
JANOŠTÍK, Václav, Michal STANĚK, David MAŇAS, Miroslav MAŇAS a Vojtěch ŠENKEŘÍK. The Influence of runner system on production of injection molds. In: MATEC Web of Conferences 20th International Conference on Circuits, Systems, Communications and Computers (CSCC 2016) [online]. Corfu: EDP Sciences, 2016 [cit. 2024-04-17]. ISSN 2261-236X. Dostupné z: https://www.matec-conferences.org/articles/matecconf/abs/2016/39/matecconf_cscc2016_02022/matecconf_cscc2016_02022.html.

Tyto citace vytvořil software a mohou obsahovat chyby. Pro ověření přesnosti si nastudujte příslušnou citační normu nebo příručku.

Související články

Attribution 4.0 International Kromě případů, kde je uvedeno jinak, licence tohoto záznamu je Attribution 4.0 International