A study on the grindability of engineering plastics and metals

Bílek, Ondřej; Baďurová, Jitka; Čop, Jiří

Název:

Autor:

Bílek, Ondřej; Baďurová, Jitka; Čop, Jiří

Typ dokumentu:

Článek ve sborníku (English)

Zdrojový dok.:

Key Engineering Materials. 2016, vol. 686, p. 137-142

ISSN:

1013-9826 (Sherpa/RoMEO, JCR)

Journal Impact This chart shows the development of journal-level impact metrics in time

JCR	Journal Citation Reports - Impact Factor
SNIP	SCImago Source Normalized Impact per Paper
SJR	SCImago Journal Rank
IPP	SCImago Impact per Publication
CS	Scopus CiteScore

(Note: The metrics are not comparable against one another.)

ISBN:

978-3-03835-625-7

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.686.137

Abstrakt:

In this study, the surface grinding was performed at different feed rates and depth of cuts. Grindability of engineering thermoplastics and metals was evaluated. Further, important process parameters influencing surface quality were determined using analysis of variance (ANOVA). Experimental results compared two significantly different groups of materials in order to emphasize common variables. Finally, further research directions were presented to seek for functional relation between process parameters and grindability. © 2016 Trans Tech Publications, Switzerland.

Zobrazit celý záznam

Soubory tohoto záznamu

Název: Fulltext_1006305.pdf

Velikost: 462.3Kb

Formát: PDF

Popis: fulltext

Citace ČSN ISO 690:2011

Citace článku v konferenčním sborníku:
BÍLEK, Ondřej, Jitka BAĎUROVÁ a Jiří ČOP. A study on the grindability of engineering plastics and metals. In: Key Engineering Materials [online]. Novi Sad: Trans Tech Publications Ltd, 2016, s. 137-142. ISSN 1013-9826.

Tyto citace vytvořil software a mohou obsahovat chyby. Pro ověření přesnosti si nastudujte příslušnou citační normu nebo příručku.