Comparison of mechanical properties of injection molded and compression molded rubber samples

Škrobák, Adam; Staněk, Michal; Kyas, Kamil; Maňas, David; Maňas, Miroslav; Řezníček, Martin; Šenkeřík, Vojtěch

dc.title	Comparison of mechanical properties of injection molded and compression molded rubber samples	en
dc.contributor.author	Škrobák, Adam
dc.contributor.author	Staněk, Michal
dc.contributor.author	Kyas, Kamil
dc.contributor.author	Maňas, David
dc.contributor.author	Maňas, Miroslav
dc.contributor.author	Řezníček, Martin
dc.contributor.author	Šenkeřík, Vojtěch
dc.relation.ispartof	International Journal of Mechanics
dc.identifier.issn	1998-4448 Scopus Sources, Sherpa/RoMEO, JCR
dc.date.issued	2013
utb.relation.volume	7
utb.relation.issue	4
dc.citation.spage	409
dc.citation.epage	416
dc.type	article
dc.language.iso	en
dc.publisher	North Atlantic University Union (NAUN)	en
dc.relation.uri	http://www.naun.org/main/NAUN/mechanics/d082002-174.pdf
dc.subject	Compression molding	en
dc.subject	Dumbbell	en
dc.subject	Graves	en
dc.subject	Injection molding	en
dc.subject	Mechanical properties	en
dc.subject	Rubber	en
dc.description.abstract	This article demonstrates what influence has a change in production technology on mechanical properties of rubber testing samples. It compares two basic production technologies - compression molding and injection molding. The aim of this research is to show and evaluate to what extent the mechanical properties are influenced by the used production technology and to quantify this potential difference on the basis of mechanical tests.	en
utb.faculty	Faculty of Technology
dc.identifier.uri	http://hdl.handle.net/10563/1003529
utb.identifier.obdid	43870209
utb.identifier.scopus	2-s2.0-84886393467
utb.source	j-scopus
dc.date.accessioned	2013-11-26T13:19:11Z
dc.date.available	2013-11-26T13:19:11Z
utb.contributor.internalauthor	Škrobák, Adam
utb.contributor.internalauthor	Staněk, Michal
utb.contributor.internalauthor	Kyas, Kamil
utb.contributor.internalauthor	Maňas, David
utb.contributor.internalauthor	Maňas, Miroslav
utb.contributor.internalauthor	Řezníček, Martin
utb.contributor.internalauthor	Šenkeřík, Vojtěch
utb.fulltext.affiliation	A. Skrobak, M. Stanek, K. Kyas, D. Manas, M. Manas, M. Reznicek and V. Senkerik
utb.fulltext.dates	-
utb.fulltext.sponsorship	This paper is supported by the internal grant of TBU in Zlin No. IGA/FT/2013/020 funded from the resources of specific university research and by the European Regional Development Fund under the project CEBIA-Tech No. CZ.1.05/2.1.00/03.
utb.fulltext.faculty	-
utb.fulltext.ou	-