Impact resistance study of high-density polyethylene through drop-weight and tensile impact tests

Mizera, Aleš; Maňas, Miroslav; Maňas, David; Stoklásek, Pavel; Hýlova, Lenka

Název:

Autor:

Mizera, Aleš; Maňas, Miroslav; Maňas, David; Stoklásek, Pavel; Hýlova, Lenka

Typ dokumentu:

Kapitola v odborné knize (English)

ISSN:

0255-5476 (Sherpa/RoMEO, JCR)

Journal Impact This chart shows the development of journal-level impact metrics in time

JCR	Journal Citation Reports - Impact Factor
SNIP	SCImago Source Normalized Impact per Paper
SJR	SCImago Journal Rank
IPP	SCImago Impact per Publication
CS	Scopus CiteScore

(Note: The metrics are not comparable against one another.)

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.919.246

Abstrakt:

This study deals with high-density polyethylene (HDPE) which was put to the drop weight and tensile impact tests. HDPE is very widespread thermoplastic polymer, especially in common applications such as packaging, consumer goods and car tanks. The injection moulded HDPE samples were subjected the drop weight impact test at six different potential energies (30, 50, 100, 150, 200 and 230 J) and measured data was evaluated. The second test was performed on pendulum test machine where impact resistance in tensile was studied. It was found out that HDPE is a low-cost material with high-performance properties in the field of the impact resistance which was evaluated in penetration and tensile test where the plastic deformation creates. © 2018 Trans Tech Publications, Switzerland.

Plný text:

https://www.scientific.net/MSF.919.246

Zobrazit celý záznam