TBU Publications
Repository of TBU Publications

Hardness and micro-indentation hardness comparison of recycled modified HDPE

DSpace Repository

Show simple item record


dc.title Hardness and micro-indentation hardness comparison of recycled modified HDPE en
dc.contributor.author Navrátil, Jan
dc.contributor.author Maňas, Miroslav
dc.contributor.author Staněk, Michal
dc.contributor.author Maňas, David
dc.contributor.author Ovsík, Martin
dc.contributor.author Bednařík, Martin
dc.contributor.author Mizera, Aleš
dc.relation.ispartof Key Engineering Materials
dc.identifier.issn 1013-9826 Scopus Sources, Sherpa/RoMEO, JCR
dc.identifier.isbn 9783038350620
dc.date.issued 2014
utb.relation.volume 606
dc.citation.spage 217
dc.citation.epage 220
dc.event.title 10th International Conference on Local Mechanical Properties, LMP 2013
dc.event.location Kutná Hora
utb.event.state-en Czech Republic
utb.event.state-cs Česká republika
dc.event.sdate 2013-11-06
dc.event.edate 2013-11-08
dc.type conferenceObject
dc.language.iso en
dc.publisher Trans Tech Publications Ltd
dc.identifier.doi 10.4028/www.scientific.net/KEM.606.217
dc.subject Hardness en
dc.subject HDPE en
dc.subject Irradiation en
dc.subject Micro-indentation hardness en
dc.subject Modification en
dc.subject Recycling en
dc.description.abstract This research paper deals with the possible utilization of irradiated high-density polyethylene (HDPE) after its service life. Powder of recycled irradiated HDPE is used as filler into virgin low-density polyethylene (LDPE) in concentrations from 10 to 60 %. Two combinations of materials were tested - granules LDPE/powder HDPE and powder LDPE/powder HDPE. Influence of the filler of the resulting blends on hardness and micro-indentation hardness was investigated. Shore D hardness test and instrumented micro-indentation hardness test were performed and results compared. According to the measured data both tested material characteristics are significantly influenced by the amount of the filler. Hardness increased with increasing amount of the filler at both material combinations; however results of micro-indentation test shows little inconsistency in hardness of surface layer. © (2014) Trans Tech Publications, Switzerland. en
utb.faculty Faculty of Technology
utb.faculty Faculty of Applied Informatics
dc.identifier.uri http://hdl.handle.net/10563/1004637
utb.identifier.obdid 43871854
utb.identifier.scopus 2-s2.0-84898917540
utb.identifier.coden KEMAE
utb.source d-scopus
dc.date.accessioned 2015-06-04T12:54:36Z
dc.date.available 2015-06-04T12:54:36Z
utb.contributor.internalauthor Navrátil, Jan
utb.contributor.internalauthor Maňas, Miroslav
utb.contributor.internalauthor Staněk, Michal
utb.contributor.internalauthor Maňas, David
utb.contributor.internalauthor Ovsík, Martin
utb.contributor.internalauthor Bednařík, Martin
utb.contributor.internalauthor Mizera, Aleš
Find Full text

Files in this item

Show simple item record