Publikace UTB
Repozitář publikační činnosti UTB

Biodiesel from rapeseed and sunflower oil: Effect of the transesterification conditions and oxidation stability

Repozitář DSpace/Manakin

Zobrazit minimální záznam


dc.title Biodiesel from rapeseed and sunflower oil: Effect of the transesterification conditions and oxidation stability en
dc.contributor.author Khan, Elena
dc.contributor.author Özaltin, Kadir
dc.contributor.author Spagnuolo, Damiano
dc.contributor.author Bernal-Ballén, Andrés
dc.contributor.author Piskunov, Maxim V.
dc.contributor.author Di Martino, Antonio
dc.relation.ispartof Energies
dc.identifier.issn 1996-1073 Scopus Sources, Sherpa/RoMEO, JCR
dc.date.issued 2023
utb.relation.volume 16
utb.relation.issue 2
dc.type article
dc.language.iso en
dc.publisher MDPI
dc.identifier.doi 10.3390/en16020657
dc.relation.uri https://www.mdpi.com/1996-1073/16/2/657
dc.subject biofuel en
dc.subject rapeseed oil en
dc.subject sunflower oil en
dc.subject transesterification en
dc.subject catechol en
dc.subject 4-allyl-2,6-dimethoxyphenol en
dc.description.abstract In this study, we produced biodiesel fuel from two vegetal sources, rapeseed oil and sunflower oil, by transesterification reaction. The study aims to evaluate the impact of type of alcohol, its concentration and the reaction time, while keeping constant the temperature and the catalyst on the yield and quality of the biodiesel. For alcohol, methanol and ethanol were used at a molar ratio with the oil from 3 to 24. Transesterification was performed at various reaction times; 20, 40, 60 and 90 min for each oil and defined alcohol:oil molar ratio. The influence of these parameters on the biodiesel yield and properties were investigated in terms of density, viscosity, heating value, flash point, elemental content, density and oxidative stability of the final product. The benefit of oxidation stabilizers, catechol and 4-allyl-2,6-dimethoxyphenol was investigated. Results demonstrate that for rapeseed oil, the optimum reaction conditions to obtain a higher yield and quality of biodiesel were an alcohol:oil molar ratio of 15:1, with 60-min reaction time at 50 degrees C; while in the case of sunflower oil, the best yield and biodiesel quality were at an 18:1 molar ratio, with a 40-min reaction time and at 50 degrees C. In both cases, methanol provides the highest yields of biodiesel, and the obtained products satisfy the required standards and present a similarity with mineral diesel tested in same conditions. en
utb.faculty University Institute
dc.identifier.uri http://hdl.handle.net/10563/1011386
utb.identifier.obdid 43884751
utb.identifier.scopus 2-s2.0-85146581203
utb.identifier.wok 000915163200001
utb.source j-scopus
dc.date.accessioned 2023-02-17T00:08:31Z
dc.date.available 2023-02-17T00:08:31Z
dc.description.sponsorship Ministry of Education and Science of the Russian Federation, Minobrnauka: 075-03-2021-287/6, WSWW-2020-0011
dc.description.sponsorship Ministry of Education and Science of the Russian Federation [075-03-2021-287/6]; Ministry of Science and Higher Education of the Russian Federation: Science [WSWW-2020-0011]
dc.rights Attribution 4.0 International
dc.rights.uri https://creativecommons.org/licenses/by/4.0/
dc.rights.access openAccess
utb.ou Centre of Polymer Systems
utb.contributor.internalauthor Özaltin, Kadir
utb.fulltext.sponsorship This research was funded by the Ministry of Education and Science of the Russian Federation (075-03-2021-287/6) and the Ministry of Science and Higher Education of the Russian Federation: Science WSWW-2020-0011.
utb.wos.affiliation [Khan, Elena; Di Martino, Antonio] Tomsk Polytech Univ, Res Sch Chem & Appl Biomed Sci, Lenin Ave 43, Tomsk 63400, Russia; [Ozaltin, Kadir] Tomas Bata Univ Zlin, Univ Inst, Ctr Polymer Syst, Nam TGM 5555, Zlin 76001, Czech Republic; [Spagnuolo, Damiano] Univ Messina, Dept Chem Biol Pharmaceut & Environm Sci, Sal Sperone 31, I-98166 Messina, Italy; [Bernal-Ballen, Andres] Univ Antonio Narino, Fac Educ, Grp Invest Conciencia, Calle 22 Sur 12D-81, Bogota 111821, Colombia; [Piskunov, Maxim V.] Tomsk Polytech Univ, Heat Mass Transfer Lab, Lenin Ave 43, Tomsk 63400, Russia
utb.scopus.affiliation Research School of Chemistry & Applied Biomedical Sciences, Tomsk Polytechnic University, Lenin Avenue 43, Tomsk, 63400, Russian Federation; Centre of Polymer Systems, University Institute, Tomas Bata University in Zlin, Nam. T.G.M. 5555, Zlin, 76001, Czech Republic; Department of Chemical, Biological, Pharmaceutical and Environmental Sciences, University of Messina, Salita Sperone 31, Messina, 98166, Italy; Facultad de Educación, Grupo de investigacion Conciencia, Universidad Antonio Nariño, Calle 22 sur No. 12D-81, Bogota, 111821, Colombia; Heat Mass Transfer Laboratory, Tomsk Polytechnic University, Lenin Avenue 43, Tomsk, 63400, Russian Federation
Find Full text

Soubory tohoto záznamu

Zobrazit minimální záznam

Attribution 4.0 International Kromě případů, kde je uvedeno jinak, licence tohoto záznamu je Attribution 4.0 International